[SUN] Problems with XVR-4000 graphics board and V880z, and Xservers config
From: David Foster (foster_at_ncmir.ucsd.edu)
Date: 11/26/03
- Previous message: Marco Wilkins: "Sending Page Via Modem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Wed, 26 Nov 2003 12:10:05 -0800 (PST) To: sunmanagers@sunmanagers.org
Platform: V880z with 2 XVR-4000 graphics boards.
XVR-100 is console framebuffer.
Solaris 9 (8/03) -- includes XVR-4000 drivers etc.
After installing 2 XVR-4000 graphics boards into our new V880z
system, the system does not recognize the boards from the 'ok' prompt
using "show-displays".
Strangely enough it seems to recognize them once booted up but does not
recognize them as configurable devices:
# fbconfig -list
Device-Filename Specific Config Program
--------------- -----------------------
/dev/fbs/zulu0 not configurable
/dev/fbs/zulu0a not configurable
/dev/fbs/zulu0b not configurable
/dev/fbs/pfb2 SUNWpfb_config
/dev/fbs/pfb2a SUNWpfb_config
/dev/fbs/pfb2b SUNWpfb_config
If I try to do anything with 'fbconfig' I get:
# fbconfig -dev /dev/fbs/zulu0 -res \?
fbconfig: Not a configurable device. Use -list for valid devices.
I followed the instructions exactly and indeed did (several)
reconfiguration reboots. Any ideas?
Also, can anyone help me with the /usr/dt/config/Xservers configuration?
The man pages and installation docs are terrible. Specifically, we want
to have the XVR-100 be the main system console, and have four
independent terminals connected to the 2 XVR-4000 boards (supports two
each).
I would be most grateful if someone could help me with the Xservers
file configuration for this. When I follow the instructions in
"Sun Fire V880z Server and Sun XVR-4000 Graphics Accelerator Installation
and User's Guide" and try something like:
:0 Local local_uid@console root /usr/openwin/bin/Xsun \
-dev /dev/fbs/ifb0 -dev /dev/fbs/zulu0 -dev /dev/fbs/zulu1
I don't even get a console. Of course this seems wrong, I would think
one would need a separate line for each console with entries for :1
etc., but there are NO examples of this anywhere that I can find.
These XVR-4000 boards are brand new. Any help much appreciated!
Dave Foster
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
David Foster National Center for Microscopy and Imaging Research
Programmer/Analyst University of California, San Diego
dfoster[at]ucsd[dot]edu Department of Neuroscience, Mail 0608
(858) 534-7968 http://ncmir.ucsd.edu/
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
"The reasonable man adapts himself to the world; the unreasonable one
persists in trying to adapt the world to himself. Therefore, all progress
depends on the unreasonable." -- George Bernard Shaw
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
- Previous message: Marco Wilkins: "Sending Page Via Modem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
