question with display error
From: GoijI P (goijiud_at_hotmail.com)
Date: 04/22/04
- Previous message: Nguyen, David M: "Fail to boot"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: sunmanagers@sunmanagers.org Date: Wed, 21 Apr 2004 18:27:04 -0400
got an utra10 with solaris2.8.
seems like SUN display monitor is bad with "no input signal"
message. (Green indocator turns to yellow on two ultra10's).
how do i know if m64config or fbconfig is used to configure
the graphic card?.
how to re-enable built-in display port with a new NIC or Sony
monitor?. just take the graphic card out , reboot it and plug in
the SONY monitor into buil-in monitor port?.
_________________________________________________________________
>From must-see cities to the best beaches, plan a getaway with the Spring
Travel Guide! http://special.msn.com/local/springtravel.armx
_______________________________________________
sunmanagers mailing list
sunmanagers@sunmanagers.org
http://www.sunmanagers.org/mailman/listinfo/sunmanagers
- Previous message: Nguyen, David M: "Fail to boot"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
