Problem on E4000

From: Isaac Lipkowitz (Isaac.Lipkowitz_at_uhi.ac.uk)
Date: 06/04/05

  • Next message: Willi Burmeister: "strange "cc -E" behaviour" 
    Date: Sat, 04 Jun 2005 14:31:15 +0100
To: <sunmanagers@sunmanagers.org>

    Hi all,

    I have an E4000 which runs Solaris 10.

    Every morning I find that the monitor is in sleep mode and won't wake up.

    I have to switch the machine off and restart it.

    There doesn't seem to be a power option any longer so where to look......

    The graphics card is a TurboGX Plus (I've tried several) running from the main
    I/O board which is the later cersion with "proper" GBICs instead of the older
    FC-AL.

    BtW, the monitor (again several tried) tends to jitter. This is not the
    monitor or the graphics card so could the I/O board be a problem?

    The clock board is a 501-5635
    System boards 501-4882
    I/O board 501-4883
    I/O second board 501-4287

    any ideas anyone.

    Thanks

    Isaac Lipkowitz
    _______________________________________________
    sunmanagers mailing list
    sunmanagers@sunmanagers.org
    http://www.sunmanagers.org/mailman/listinfo/sunmanagers

  • Next message: Willi Burmeister: "strange "cc -E" behaviour"

    Relevant Pages

    • TECH: WG D9200 No VGA??
      ... I have a 9200 in a Silver Strike Bowler that works fine in Med res but ... when I plug the VGA cable into the monitor from the I/O board and set ...
      (rec.games.video.arcade.collecting)
    • Re: Vaxstation 3100 and graphics card
      ... > pin vax monitor plug to the 15 pin d-sub VGA plug. ... > happen even if the adaptor is not connected. ... and the manual does not indicate any switch or jumper ... the two switches on the graphics card). ...
      (comp.os.vms)
    • Re: Start up problem novice requires help
      ... If you get the same problem then it is probably the graphics card. ... my computer on the monitor goes into standby, I have to use the power ... switch to keep trying untill the monitor kicks in a lights up. ...
      (microsoft.public.windowsxp.general)
    • Re: No signal to monitor, please help!
      ... I changed the graphics card but still have a blank ... monitor and now it won't switch off; all I get are flashing lights ... No amount of pressing the on/off switch ... Has my monitor died or is there a way to turn it off and have normal service ...
      (alt.sys.pc-clone.dell)
    • Re: video signal reflection
      ... or video switch, or some such during your upgrade? ... connected to monitor. ... unfortunately it has no switchable termination, ... the old graphics card DID terminate the line properly. ...
      (comp.sys.ibm.pc.hardware.video)