In SE3510FC - unfail command fails to take failed controller online

Hi all... I have this problem. Have any idea?

I had a SE3510 FC with dual controllers configured active-active with
4.15 FW:

sccli> show redundancy
Primary controller serial number: 8101936
Primary controller location: Lower
Redundancy mode: Active-Active
Redundancy status: Enabled
Secondary controller serial number: 8101885

I issued a "fail" command to verify failover and transparent access to
LUNs from hosts:

sccli> fail primary
Are you sure? y

After that, I have this:

sccli> show redundancy
Primary controller serial number: 8101885
Primary controller location: Upper
Redundancy mode: Active-Active
Redundancy status: Scanning
Secondary controller serial number: 0

Everything worked just fine an the LUNs failed-over correctly. The
problem is that I can't make the failed controller go back online. I
tried:

1st option.-
sccli> unfail
Are you sure? y

sccli> show redundancy
Primary controller serial number: 8101885
Primary controller location: Upper
Redundancy mode: Active-Active
Redundancy status: Scanning
Secondary controller serial number: 0

2nd option.-

sccli> reset controller
WARNING: This is a potentially dangerous operation.
The controller will go offline for several minutes.
Data loss may occur if the controller is currently in use.
Are you sure? y
sccli: shutting down controller...
sccli: controller is shut down
sccli: resetting controller...
sccli: controller has been reset

sccli> show redundancy
Primary controller serial number: 8101885
Primary controller location: Upper
Redundancy mode: Active-Active
Redundancy status: Scanning
Secondary controller serial number: 0

What I have not tried is powering off the full array. This is my last
resort, but I want to see if there is any other option before I do
this...

Thanks and regards,
Alex
_______________________________________________
sunmanagers mailing list
sunmanagers@xxxxxxxxxxxxxxx
http://www.sunmanagers.org/mailman/listinfo/sunmanagers

Relevant Pages

  • SUMMARY: Disk contention problems
    ... If a controller had actually failed, this can trigger the array to ... sccli> show redundancy-mode ... Primary controller location: Lower ... Redundancy mode: Active-Active ...
    (SunManagers)
  • Disk contention problems
    ... and fdsyncs (which cyrus-imap seems to like using a lot) taking seconds. ... sccli> show redundancy-mode ... Primary controller location: Lower ... Redundancy mode: Active-Active ...
    (SunManagers)
  • Re: 3310 RAID1 (mirror) Question
    ... I downloaded and installed sccli, but can't get info on the 3310 ... because it's not the primary controller. ... On my 3510s with two logical drives, ...
    (comp.unix.solaris)
  • SUMMARY: In SE3510FC - unfail command fails to take failed controller online
    ... sccli> show redundancy ... Primary controller location: Lower ... Redundancy mode: Active-Active ...
    (SunManagers)
  • Re: 3310 RAID1 (mirror) Question
    ... I downloaded and installed sccli, but can't get info on the 3310 ... because it's not the primary controller. ... the "Edit Logical Drives" section, there is a submenu named "Logical ...
    (comp.unix.solaris)