T3+ firmware level 2 FW mismatch

Folks -

I have a V480 running Sol 9 9/04, just patched with most recent
recommended patch cluster, along with SAN 4.4.11. I have a partner paired
T3+ attached to this server. the T3+ is running 3.2.5 level 3 firmware,
and 5.02 Interconnect Card Firmware.

My possible problem is that the REVISION is different on the contoller
cards:

ID TYPE VENDOR MODEL REVISION SERIAL
------ ----------------- ----------- ----------- -------------
--------
u1ctr controller card 0x301 5015710 52 113780
u2ctr controller card 0x301 5015710 57 135097


This Controller Card was recently replaced, and I just noticed this
difference. From some older docs I found, this is the level 2 firmware
version,
and should get upgraded when you do a "ep download t3l3_325.bin", though
the README for the 3.2.5 patch does not say this specifically. Running
this command did not change/upgrade the revision at all.

I can't find anything that says this condition is acceptable or not, nor
can I find a way to make them the same.

Has anyone seen this problem and have some information to pass along?

Thanks!
============================================================================
Charles Mengel
=============================================================================
_______________________________________________
sunmanagers mailing list
sunmanagers@xxxxxxxxxxxxxxx
http://www.sunmanagers.org/mailman/listinfo/sunmanagers