wanboot jumpstart issue

I am doing a jumpstart via wanboot and it keeps getting stuck because the
flar I am using has an interface already configured as you can see below....
Can I get around this?

krtld: Unused kernel arguments: `install'.
SunOS Release 5.10 Version Generic_120011-14 64-bit
Copyright 1983-2007 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
call to undefined service "fstat"
Can't stat misc/forthdebug stat=186ef80 sz=0
Configuring devices.
Network interface was configured manually.
192.168.4.6
Beginning system identification...
syslogd: line 24: WARNING: loghost could not be resolved
Searching for configuration file(s)...
Jan 30 09:16:16 testwan eri: SUNW,eri0 : 100 Mbps full duplex link up
Using sysid configuration file
http://192.168.3.5/config/sysid/172.29.3.0/sysidcfg
Search complete.
Discovering additional network configuration...
Completing system identification...
Starting remote procedure call (RPC) services: done.

- The Solaris Installation Program
---------------------------------------------

The Solaris installation program is divided into a series of short
sections
where you'll be prompted to provide information for the installation. At
the end of each section, you'll be able to change the selections you've
made before continuing.

About navigation...
- The mouse cannot be used
- If your keyboard does not have function keys, or they do not
respond, press ESC; the legend at the bottom of the screen
will change to show the ESC keys to use for navigation.
_______________________________________________
sunmanagers mailing list
sunmanagers@xxxxxxxxxxxxxxx
http://www.sunmanagers.org/mailman/listinfo/sunmanagers

Relevant Pages

  • 2.6.18.3 Lockup on Athlon MP
    ... I am sure it's not just a hardware issue, though, ... as well as the kernel configuration I am using. ... # ACPI (Advanced Configuration and Power Interface) Support ...
    (Linux-Kernel)
  • Slow Point to Point T1 Access Please Help
    ... interface FastEthernet0/0 ... DRAM configuration is 64 bits wide with parity disabled. ... minute output rate 7000 bits/sec, 7 packets/sec ... output buffer failures, ...
    (comp.dcom.sys.cisco)
  • Re: Slow Point to Point T1 Access Please Help
    ... interface FastEthernet0/0 ... DRAM configuration is 64 bits wide with parity disabled. ... minute output rate 7000 bits/sec, 7 packets/sec ... output buffer failures, ...
    (comp.dcom.sys.cisco)
  • Re: T1 lines go mad
    ... >> Can you post the interface configs as well as a show interface for each ... > Building configuration... ... > 0 output buffer failures, ...
    (comp.dcom.sys.cisco)
  • Cisco 857 Ethernet0 wont stay up unless constant ping is done.
    ... Current configuration: 5525 bytes ... interface ATM0.1 point-to-point ... ip nat inside source route-map SDM_RMAP_1 interface Dialer0 overload ... transport preferred all ...
    (comp.dcom.sys.cisco)