FastFD mode on tu cards not working?

From: QB=FCtow=2C_Michael=22?= (michael.buetow_at_comsoft.de)
Date: 05/05/04

  • Next message: Andrew Raine: "SUMMARY: gnu-R for Tru64 5.1 pk3" 
    Date: Wed, 05 May 2004 09:31:35 +0200
To: tru64-unix-managers@ornl.gov

    Hello all,

    A colleague of mine has had problems not being able to
    use tu Ethernet interfaces in full duplex mode on DS10.

    He reported setting the interfaces (onboard and on an
    interface card, but all Tulip chipset) to FastFD on the
    SRM console.
    The operating system (Tru64 v4.0F) reports these cards
    as full duplex.
    However, he tried connecting with two different switches
    and was able to get 100Mb/s, but NOT full duplex.

    Is this a known / verified problem?

    Best regards,
    Michael

  • Next message: Andrew Raine: "SUMMARY: gnu-R for Tru64 5.1 pk3"

    Relevant Pages

    • routes disappear
      ... netstat to report no routes. ... the latest box to do this has two interfaces (this one has tg3 interfaces, ... full duplex. ... code 1 error to a broadcast: ...
      (Linux-Kernel)
    • Re: full/half duplex problem
      ... The bge interfaces by default come up as half duplex, ... that autoneg had to be on for Gigabit. ... same to the lower switch module bge1, it comes up as FULL duplex! ...
      (comp.unix.solaris)
    • Re: XP very slow to write data in a W2k share
      ... the switch interfaces are forced to. ... full duplex. ... On the workstations, a software reads files on the share, an operator ... poor performances, so any help would be appreciated ...
      (microsoft.public.windowsxp.network_web)
    • Re: Router Config Problem
      ... two interfaces? ... connecting FastEthernet to Ethernet. ... duplex at half or full. ... Since there must be transceivers involved, ...
      (comp.dcom.sys.cisco)