ES40 Fan2 failed

From: Siebert, Aaron (aaron.siebert_at_nagrastar.com)
Date: 05/06/05

  • Next message: Garsha, Adam: "SUMMARY: Tru64 Version Naming Question" 
    Date: Fri, 06 May 2005 15:00:45 -0600
To: tru64-unix-managers@ornl.gov

    Managers,

    We have an ES40 that the lcd panel displays "Fan2 failed"

    Does anyone know which fan or replacement part this would require to
    request from a vendor?

    TIA

    Regards,

    Aaron Siebert
    Nagrastar Customer Support Engineer
    Aaron.Siebert@NagraStar.com
    D - 3037065492 F - 3037065719

  • Next message: Garsha, Adam: "SUMMARY: Tru64 Version Naming Question"

    Relevant Pages

    • Re: Faulty graphics from onboard VGA in A8N-VM CSM
      ... Send the motherboard today to the vendor. ... checked and then offer a replacement. ... Hope i get a new one and teh ... Anyway had a tough time getting the fan off the microprocessor. ...
      (alt.comp.periphs.mainboard.asus)
    • Re: Vasif may have not corrupted my CPU after all.
      ... There was hardly any air flowing through it, whereas with the 350W PSU there is lots of air. ... There was a dead end at the top of the case on the right of the 550W PSU since it had its fan facing below over the processor. ... The replacement went the following years, and the replacement of the replacement went soon after that. ...
      (soc.culture.greek)
    • Re: Vasif may have not corrupted my CPU after all.
      ... There was hardly any air flowing through it, whereas with the 350W PSU there is lots of air. ... There was a dead end at the top of the case on the right of the 550W PSU since it had its fan facing below over the processor. ... The replacement went the following years, and the replacement of the replacement went soon after that. ...
      (soc.culture.greek)
    • Re: Help with relationships
      ... This is to be a Requisition Request. ... combobox that when I select the vendor, all the other information about the ... >> MISNumber - Number ...
      (microsoft.public.access.gettingstarted)
    • Re: noisy power supply fan on sun blade 100
      ... the fan in the power supply is getting noisier and noiser. ... Dying bearings. ... Have you tried going to eBay and looking for a replacement from ... Or -- you could find a Blade 100 on eBay for a low price, ...
      (comp.sys.sun.hardware)