Re: Changing subnet and gateway on Alpha800 running VMS 7.3
From: Mike Rechtman (rechtman_at_tzora.co.il)
Date: 11/10/04
- Next message: Dale Dellutri: "Re: how to implement an append only log file?"
- Previous message: Johnny Hosp: "Changing subnet and gateway on Alpha800 running VMS 7.3"
- In reply to: Johnny Hosp: "Changing subnet and gateway on Alpha800 running VMS 7.3"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Wed, 10 Nov 2004 21:56:53 +0200
Johnny Hosp wrote:
> New to VMS, any help would be appreciated. We would like to change our
> subnet mask and gateway on our alpha box running VMS version 7.3. I
> have gone into UCX and viewed the settings. At first try I was not
> able to permanently change the subnet/gateway, it showed both the
> original addresses and an entry for our new addresses we defined. When
> we rebooted, the new entry was gone and the old address scheme was
> still in place. Funny thing is that when we connected the new box to
> our new network it still connected without issue, even though it had
> the old mask and gateway defined. What am I missing to configure this
> properly?
> Thanks,
> Cory
1. Try the documentation. Online at
http://h71000.www7.hp.com/doc/tcpip53.html (with ponters to V5.1 and V5.4)
2. Did you use @SYS$MANAGER:TCPIP$CONFIG ( UCX$CONFIG for pre V5.0 )
Its a menu-driven command-file that does most of the basic TCPIP/UCX
configuratio.
HTH
Mike
-- New to Usenet? read http://eisner.encompasserve.org/~rechtman/post_hlp.htm --------------------------------------------------------------------- Usual disclaimer: All opinions are mine alone, perhaps not even that. Mike Rechtman *rechtman@tzora.co.il* "20% of a job takes 80% of the time, the rest takes another 80%" ---------------------------------------------------------------------
- Next message: Dale Dellutri: "Re: how to implement an append only log file?"
- Previous message: Johnny Hosp: "Changing subnet and gateway on Alpha800 running VMS 7.3"
- In reply to: Johnny Hosp: "Changing subnet and gateway on Alpha800 running VMS 7.3"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
