circuit up/circuit down . . . messages filling up OPERATOR.LOG



In the last twenty-four hours alone, the logfile for my IA64 box has
8250 messages
warning the circuit is down with 8251 celebrating that the circuit is
up.
"Circuit EIA-0, Line synchronization lost"
Precisely every ten seconds, followed *immediately* by the "up"
message.

Jerry Leslie and Gareth Davies each posted about the exact same problem
over ten years ago, but but there were no useful followups, except to
check
the cables; I've swapped cables to no effect. And, of course, as any
seasoned
computer person could have guessed, DECnet has been working just fine
the entire time. I've been copying files in both directions without
any error
and good speed. Any thoughts?

ok
dpm

.



Relevant Pages

  • Re: Intel rejects Vista, will stay with XP and wait for windows7
    ... Then, *at run-time*, other components in the circuit have a ... but this is they way some .NET programmers ... WARNING - Humidity out of range for this type of capacitor. ... engineer who designed the circuit, or the 5-year-old who is looking at ...
    (sci.electronics.design)
  • Re: Intel rejects Vista, will stay with XP and wait for windows7
    ... Then, *at run-time*, other components in the circuit have a ... but this is they way some .NET programmers ... WARNING - Humidity out of range for this type of capacitor. ... engineer who designed the circuit, or the 5-year-old who is looking at ...
    (sci.electronics.design)
  • Re: Intel rejects Vista, will stay with XP and wait for windows7
    ... Then, *at run-time*, other components in the circuit have a ... but this is they way some .NET programmers ... WARNING - Humidity out of range for this type of capacitor. ... engineer who designed the circuit, or the 5-year-old who is looking at ...
    (sci.electronics.design)
  • Re: circuit up/circuit down . . . messages filling up OPERATOR.LOG
    ... > warning the circuit is down with 8251 celebrating that the circuit is ... > Jerry Leslie and Gareth Davies each posted about the exact same problem ... I've swapped cables to no effect. ... I believe that if you try to use DECnet routing but only have an end ...
    (comp.os.vms)
  • Re: Motor Control Circuit Problem
    ... > Out of interest I tried simulating the original circuit ... > Warning: source stepping failed ... > Anyone care to try it in some other package please, ...
    (sci.electronics.cad)