Re: How to boot a micro PDP-11 (newbie question)
healyzh_at_aracnet.com
Date: 10/17/03
- Next message: Luca_B: "Re: VAX 4000/500 general questions"
- Previous message: H Vlems: "Re: VAX 4000/500 general questions"
- In reply to: Slavko Vorkapitch: "Re: How to boot a micro PDP-11 (newbie question)"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: 17 Oct 2003 01:30:13 GMT
Slavko Vorkapitch <el_squid_2000@yahoo.com> wrote:
> It puts me into some kinda device setup screen -
> starts off with KDJ11-E Monitor Version 1.06 30-Jul-1990
> Memory
> EEPROM
> Nr Device Unit Address
> 1 DU 1 Default
> 2 DL 0 Default
> 3 MU 0 Default
> 4 DU 0 Default
> 5
> And a bunch of other stuff on the same screen..
> Initially it powered up with a menu selection of Boot, Set up or
> Help..
> I just pressed enter and was put into the Monitor screen described
> above - for some reason I can't escape from this now.
Interesting. I'm not to sure what you're stuck in. You should have been
able to tell it boot, and then when it asks you what disk to boot from. It
sounds like, as I suspected, you've got a boot menu very close to what I
have on my PDP-11/73.
My recommendation is that you post your question to either the vmsnet.pdp-11
or alt.sys.pdp11 newsgroups. The chances of finding someone there that
knows is far greater than here.
Zane
- Next message: Luca_B: "Re: VAX 4000/500 general questions"
- Previous message: H Vlems: "Re: VAX 4000/500 general questions"
- In reply to: Slavko Vorkapitch: "Re: How to boot a micro PDP-11 (newbie question)"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
