Re: pws 500au problems
From: Tom Linden (tom_at_kednos.com)
Date: 09/08/05
- Previous message: Tom Linden: "Re: pws 500au problems"
- Maybe in reply to: Tom Linden: "Re: pws 500au problems"
- Next in thread: Crabs: "Re: pws 500au problems"
- Reply: Crabs: "Re: pws 500au problems"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Wed, 07 Sep 2005 16:48:31 -0700
On Thu, 8 Sep 2005 01:25:27 +0200, Peter Huybrechts <m713007@hotmail.com>
wrote:
> ok guys.. everything seems to work fine now.
> I was a little too quick with my reactions.
> removal of the battery worked, and have put the default rom (via cmos
> setup)
> to SRM.
> now it's an au system.. OpenVMS will install fiine.
>
> Thanks to everybody who responded so quick !
> :-)))
>
>
> "Peter Huybrechts" <m713007@hotmail.com> wrote in message
> news:431f4782$0$6578$ba620e4c@news.skynet.be...
>> Hi,
>> I bought a pws 500au but this machine gives some problems.
>> The Powerup Codes of the leds give code E4 (Memory address line error).
>> The system boots into FreeBSD and seems to work ok. Problem is I can't
>> get
>> it into SRM mode.... Pressing Ctrl-C at boot time, nor disconnecting
>> boot
>> drive works.
>> Somebody any Idea what's wrong ? (maybe something wrong in the flash rom
>> ??)
The difference between A and AU or Miata and Miata GL were two that I can
think of,
The GL remebers the state of the power switch after interruption and will
power
itself backup assuming AUTO_ACTION is set to restart and GL had onboard
SCSI.
BTW. I have previously posted the dip switch setting to run this at
600MHz, which
I have successfully done on both 500's and 433's. It will not cause any
damage.
>>
>> Thanks,
>> Peter
>>
>
>
- Previous message: Tom Linden: "Re: pws 500au problems"
- Maybe in reply to: Tom Linden: "Re: pws 500au problems"
- Next in thread: Crabs: "Re: pws 500au problems"
- Reply: Crabs: "Re: pws 500au problems"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|