Re: DECserver 90M info

In article <4447CAF6.3020002@xxxxxxxxxxxxxxxxxxx>, Chris Scheers <chris@xxxxxxxxxxxxxxxxxxx> writes:
I have MNENG1 and MNENG2, but no MNENG3. If MNENG3 is just a
decompressed MNENG2, is there a way for me to create it from MNENG2?

Not that I know of. But that doesn't mean anything...

Also, the owner's manual doesn't really discuss flash variants. Were
there units sold with no flash? Once I get the 90M up and issue a SHOW
MEMORY command, it tells me that there is no flash installed.

Yes, there have been 0MB, 1MB and 2MB variants.

Local> sh mem

Dynamic RAM: 4 M bytes

Non-Volatile RAM: 32 K bytes

Flash RAM:
Installed: Yes
Total size: 2 M bytes
Boot block: Valid
Load Image:
Name: MNENG3
Size: 1615788 bytes
Version: Network Access SW V2.4 BL50

btw: Does anyone have a newer than V2.4 version?

--
Peter "EPLAN" LANGSTOEGER
Network and OpenVMS system specialist
E-mail peter@xxxxxxxxxxxxxx
A-1030 VIENNA AUSTRIA I'm not a pessimist, I'm a realist
.

Relevant Pages

  • Re: DECserver 90M info
    ... decompressed MNENG2, is there a way for me to create it from MNENG2? ... there units sold with no flash? ... Once I get the 90M up and issue a SHOW MEMORY command, it tells me that there is no flash installed. ...
    (comp.sys.dec)
  • Re: DECserver 90M info
    ... decompressed MNENG2, is there a way for me to create it from MNENG2? ... Once I get the 90M up and issue a SHOW MEMORY command, it tells me that there is no flash installed. ... Is the memory PCMCIA card memory like the DECserver 700s, ...
    (comp.sys.dec)
  • Re: DECserver 90M info
    ... decompressed MNENG2, is there a way for me to create it from MNENG2? ... MEMORY command, it tells me that there is no flash installed. ... Does it have a slot for a PCMCIA card? ...
    (comp.sys.dec)
  • Re: DECserver 90M info
    ... Also, when booting, it asks for MNENG2.SYS as a load file. ... you need a bigger flash for the MNENG3 in the flash. ... And I found the manual courtesy of www.archive.org. ... decompressed MNENG2, is there a way for me to create it from MNENG2? ...
    (comp.sys.dec)