Re: How can I configure the font of lp command
From: Greg Andrews (gerg_at_panix.com)
Date: 11/27/03
- Next message: Stefaan A Eeckels: "Re: Two mail servers on the same domain"
- Previous message: Michael Tosch: "Re: CDE question"
- In reply to: ehab: "How can I configure the font of lp command"
- Next in thread: Mark R.Bannister: "Re: How can I configure the font of lp command"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Thu, 27 Nov 2003 19:10:52 +0000 (UTC)
hpy_azizy@yahoo.com (ehab) writes:
>
>How can I change the font size of lp commands with Solaris 8 x86.
>Using HP laserjet printer 6L.
>
The stock Solaris printer interface doesn't know how to tell the
Laserjet to switch fonts. The most widely used software that
does know how to do this, HP's Jetadmin/Jetdirect software,
doesn't support Solaris x86 (though you can use its interfaces
if your printer is connected to your parallel port).
People have posted a URL to an ancient version of the Jetadmin
software that works on Solaris x86. A search of these groups
on groups.google.com should reveal it to you.
Otherwise, you'll either need to hack the Solaris interface to
issue the appropriate PCL codes, or use commercial software like
PShop at www.vividata.com.
-Greg
-- Do NOT reply via e-mail. Reply in the newsgroup.
- Next message: Stefaan A Eeckels: "Re: Two mail servers on the same domain"
- Previous message: Michael Tosch: "Re: CDE question"
- In reply to: ehab: "How can I configure the font of lp command"
- Next in thread: Mark R.Bannister: "Re: How can I configure the font of lp command"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
