Re: AXi board and 400MHz CPU?
From: Chris Morgan (cm_at_mihalis.net)
Date: 12/23/03
- Next message: Chris Morgan: "Re: Upgrading Graphics in a Blade 100 - Elite 3d M3 or Creator 3D ?"
- Previous message: David Friedman: "Beeping"
- Next in thread: Thomas: "Re: AXi board and 400MHz CPU?"
- Reply: Thomas: "Re: AXi board and 400MHz CPU?"
- Reply: Kralizec Craig: "Re: AXi board and 400MHz CPU?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: 23 Dec 2003 12:13:44 -0500
"Thomas" <emgaron@gmx.net> writes:
> reading through the documentation available for the SparcEngine Ultra AXi
> board, I noticed that of the faster CPUs only the 360MHz and 440MHz are
> mentioned - not the 400MHz. Hence my question: Is it possible to run a
> 400MHz CPU on that board and are there any potential catches I should be
> aware should I try to do that?
AXi takes Ultrasparc-IIi, and I'm not sure there exist 400mhz versions
of those. I often see 333, 360 and 440mhz models. Avoid the 360 if
possible as it has only 256kb cache, the others have 2MB.
Chris
--
Chris Morgan
"Post posting of policy changes by the boss will result in
real rule revisions that are irreversible"
- anonymous correspondent
- Next message: Chris Morgan: "Re: Upgrading Graphics in a Blade 100 - Elite 3d M3 or Creator 3D ?"
- Previous message: David Friedman: "Beeping"
- Next in thread: Thomas: "Re: AXi board and 400MHz CPU?"
- Reply: Thomas: "Re: AXi board and 400MHz CPU?"
- Reply: Kralizec Craig: "Re: AXi board and 400MHz CPU?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
