Re: Ultra5 floppy installation

From: Andrej Sydorko (luser_at_port-nospam-alofevil.org)
Date: 02/18/05 

Date: Fri, 18 Feb 2005 09:07:27 +0100

> You need a dual headed floppy cable (one for A and B drives).
>
> Use the middle (the B drive) connector.
>
> Turn the connector around so that pin 1 goes where pin 32 is. You may
need
> to "clip" off the little plastic nib in the floppy cable.
>
> It should now work.

Ok so basically what's needed is a floppy cable like the one in the SS5.
It's completly straight.
I tried using the SS5 floppy cable with no luck.
Not really sure if I tried turning the SS5 cable pin1->pin32.
But I will try this exact sollution and see what happens.