How to reset SunFire V280R NVRAM to "factory defaults"?

Hi,

We have several SunFire V280Rs, and I need to reset their NVRAM to
"factory default".

I've seen info about going to a safe mode by double-clicking the power
button during power-on, but I think that is just temporary. I need to
find a way to reset the NVRAM so that the machines are "like they came
from the factory".

Is there any way to do this? And, if so, can anyone tell me how? What
would be perfect if I could get a pointer to a Sun document that
describes the procedure.

Thanks in advance!

Jim
.

Relevant Pages

  • Re: laptop shuts down
    ... If you cannot get into safe mode, or any reset mode - do be aware if you ... into F2 to reset factory defaults. ... looked at system infor was showing ze5300 - had used operating disk to ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Need advice on Motel Wireless Setup
    ... The factory default reset is done with the button between the power ... between AP and Bridge, you have to do it via web interface. ... can label it whatever you want in the configuration screens. ...
    (alt.internet.wireless)
  • Re: cant boot mneng3
    ... >after that the console locks up - I can't type anything, pressing reset on the front ... and therefore there are two identical image loads which ... You may have a compressed image, though it is named MNENG3... ... and all factory defaulted to MNENG3 and also my reset-script specified MNENG3). ...
    (comp.sys.dec)
  • Re: how to clear nvram on inspiron 8200? cant see both cdrom drives
    ... > the usual sequence of cmos setup, turn on num/caps/scrol lock and hit ... > i did find that alt-f did seem to reset the bios back to default settings, ... > is this a laptop where the nvram needs to be reset from a jumper on the ... if i insert the xp boot cdrom disk or dell resource boot ...
    (alt.sys.pc-clone.dell)
  • Re: Re: Adaptive learning CPU
    ... If the system is reset it resets to the factory defaults - the ... Sometimes the map is cleared altogether. ... He had a fault. ...
    (talk.origins)