Re: Ultra 1 won't start at all, sometimes
It does have a fan in the middle of a Plexiglass! So it could very well
be the fan which is broken... When I hit the switch it certainly
doesn't spin up (when it did still run it sure made some noise :p).
Could I test it for sure that it is the fan? Perhaps by shortcircuiting
the fan-is-working-signal for a split second just to see if the system
powers up?
Do you still have the dimensions and voltage measurements? (I could
measure the dimensions myself, but would not know where to look for the
voltage) In MM would be nice since I live in Europe.
Thank you very much for your help so far!
.
Relevant Pages
- Re: Ultra 1 wont start at all, sometimes
... > It does have a fan in the middle of a Plexiglass! ... As far as I can tell, there is no "fan-is-working" signal. ... > measure the dimensions myself, but would not know where to look for the ... > voltage) In MM would be nice since I live in Europe. ...
(comp.sys.sun.hardware) - Re: OT: End of an Odyssey...
... I'm surprised there isn't yet a cartoon of a fan checking the dimensions ... of his tombstone. ... Bugger! ...
(uk.comp.sys.mac) - Re: What fan size?
... Trevor is correct the dimensions you gave are for an 80mm fan and not a ... external dimension is 92mm. ...
(uk.comp.homebuilt) - Re: OT: End of an Odyssey...
... I'm surprised there isn't yet a cartoon of a fan checking the dimensions of his tombstone. ...
(uk.comp.sys.mac) - Re: 300SDL temp sensor question
... If the design is similar to OM601, the temp switch is around the coolant thermostat/outlet at the front of engine on passenger side. ... If no, trace back to the relay. ... I personally would not prefer to jump at the socket because the fan uses a big current. ... The dryer is a cylinder about the size of a soda can, probably behind driver side headlamp, half buried. ...
(alt.auto.mercedes) |
|
