Re: Ultra 60: No console (serial) or opb on monitor


"asholz" top posts:

this was the first trick!
Now I do see the OPB output on the terminal!

The machine tries to boot via the network. How can I cancel these tries
and enter the OPB command mode?

You are using TeraTerm. Send a break to get an ok prompt..

Rich Teer schrieb:
On Fri, 15 Dec 2006, asholz wrote:
I got an used U60 (dual 360Mhz, 512Mb ram, 9Gb SCSI disk, Creator 3d)
but I don't see anything on a connected monitor or terminal connected
to ttya.
Meanwhile I was able to get into POST and to see the POST messages via
Teraterm, but after POST there is the same behaviour as above.
In the following the begining and the end of the POST:
Hardware Power ON
Master CPU online
Master Version: 0000.0000.1700.11a0
Slave Version: 0000.0000.1700.11a0
CPU E$ (M) 0000.0000.0040.0000 (S) 0000.0000.0040.0000ÿ
Button Power ON
Master CPU online
Master Version: 0000.0000.1700.11a0
Slave Version: 0000.0000.1700.11a0
CPU E$ (M) 0000.0000.0040.0000 (S) 0000.0000.0040.0000

Probing keyboard Done
anny hints on what to do is very appreciated!!!
Unplug the keyboard before you turn it on.

.