E3500 Power/Cooling Module Fuse?

We have an E3500 that is, of course, long past EOL. However, we still
use it as a test box. Recently, it developed a failue of one of the
Power/Cooling Modules. We were able to replace it with another PCM
from a bone yard E3500 (which the current one is on its way to
becoming, it would seem).

The properly functioning PCMs display a solid green power indicator
LED, and a non-lit amber service indicator LED. In the malfunctioning
PCM, both LEDs were entirely off. The E3500 Reference Manual states
that that condition (Off/Off for Power and Service LEDs) means, "No AC
input".

Now, when we move the defective PCM around in the various slots, it
always has unlit LEDs, and the other two PCMs always have a properly
lit green LED, and an unlit amber LED. In other words, there is AC
available at all three of the PCM positions in the chassis. Hence,
the AC must be interrupted in the module, someplace.

That situation might hint at the possibility of a blown fuse. If so,
we wonder if the PCM might be "brought back to life" by the mere
replacement of a fuse.

A brief inspection of what is visible by removing the sheet metal
shrouding of the PCM does not reveal an obvious or accessible fuse.

Is anyone familiar with this old hardware, and able to say whether the
PCMs in the E3500 have a fuse that might be replacable?

Alternatively, might anyone have an opinion on the significance of 2
dark LEDs (= "No AC input"?

Thank you for any comments.

DG
.

Relevant Pages

  • Re: E3500 Power/Cooling Module Fuse?
    ... We were able to replace it with another PCM ... both LEDs were entirely off. ... that that condition (Off/Off for Power and Service LEDs) means, ... That situation might hint at the possibility of a blown fuse. ...
    (comp.sys.sun.hardware)
  • Re: E3500 Power/Cooling Module Fuse?
    ... Power/Cooling Modules. ... We were able to replace it with another PCM ... both LEDs were entirely off. ... That situation might hint at the possibility of a blown fuse. ...
    (comp.sys.sun.hardware)
  • Re: Another Great Amplifier Design...
    ... The LED is the regulator / reference voltage. ... LEDs have 1.5 volt across them (or some slightly higher voltage, ... don't want to blow a fuse when a fault is detected. ... So does the relay, you COULD provide a reset button, but what I do not want ...
    (rec.radio.cb)
  • Re: 240v mains to logic output?
    ... I would recommend incorporating a local quick blow very low rated fuse on the mains side. ... Your typical 6A breaker or 6-13A heating fuse will blow your board to bits before the fuse clears the fault. ... There are optos with two LEDs in there, takes care of the reverse diode and covers both half-waves with very little gap. ... are set up to verify it can't track), so why not extend your original idea and build an optoisolator with a large air gap - LED at one end of a piece of black plastic tube, photo-thingy at the other... ...
    (sci.electronics.design)
  • Re: ASD relay ?
    ... in my wiring diagram for this fuse it shows a dark blue/white wire going to ... The 12 volts on that fuse has nothing to do with the PCM. ... circuit so that the fuel pump relay stays engergized. ...
    (rec.autos.makers.chrysler)