Re: NIM Slow due to wrong Duplex
From: aix_google (sstewart14_at_kc.rr.com)
Date: 08/26/05
- Next message: macka: "convert errlog"
- Previous message: Nathan: "Re: back up non-root VG Tivoli Storage 3950"
- In reply to: steve_chicago: "NIM Slow due to wrong Duplex"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: 25 Aug 2005 17:26:34 -0700
steve_chicago wrote:
> I am installing a P610. When the server was up I checked that the
> etehrnet card is set to 100/Full. When the server was rebooted I
> checked that in the SMS that the adapter was set to 100/Full. My switch
> is set to 100/Full. But the server seems to become set to half duplex.
> this is causing the install to take a day and a half. Has anyone else
> seen this or know a way around it?
>
> Steve
I have had the problem that the adapter parameters do not stay set in
SMS. I set it to 100 Full, start a NIM install, it runs slow, look at
the adapter in SMS and it's set back to 100 Half. I upgraded the
microcode and the problem went away.
I have also had the problem that nim incorrectly identifies the
attributes of some adapters and runs very slow, usually hanging on a
622. I set the adapter to 100 Half in SMS and the install completes.
Hope this helps
Steve
- Next message: macka: "convert errlog"
- Previous message: Nathan: "Re: back up non-root VG Tivoli Storage 3950"
- In reply to: steve_chicago: "NIM Slow due to wrong Duplex"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
