Re: Dell PowerEdge 1600sc NIC
From: Bela Lubkin (belal_at_sco.com)
Date: 08/29/03
- Next message: Eric Wood: "Need Openserver 5.0.5 Media Kit"
- Previous message: Bela Lubkin: "Re: BTLD Floppy disk for Cristie CD1600"
- In reply to: Joe Chasan: "Dell PowerEdge 1600sc NIC"
- Next in thread: Nachman Yaakov Ziskind: "Re: Dell PowerEdge 1600sc NIC"
- Reply: Nachman Yaakov Ziskind: "Re: Dell PowerEdge 1600sc NIC"
- Reply: Joe Chasan: "Re: Dell PowerEdge 1600sc NIC"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Fri, 29 Aug 2003 18:30:32 GMT To: scomsc@xenitec.ca
Joe Chasan wrote:
> SCO openserver 5.07, MP1, all patches to date.
>
> Can't figure right driver for built-in NIC on Dell PowerEdge 1600sc.
>
> dell support claimed was intel pro 100, but i don't think he's correct
> (well, at least it did not recognize card when used that driver)
>
> closest i came is the Intel Pro 1000 - after the mp1 update, but
> with Bus 0/Device 2/Function 0 - i get a ton of garbage spewed onto
> the console (even though card works and is recognized) from the eeG driver.
>
> "Queue (some large negative # that changes) allready open"
>
> for now, disabled and went back to my trusty 3com 905b...
>
> anyone know correct driver?
Run `hr -v -r pci > /tmp/pci`. Find the entry that describes the
network controller, post it. Then we'll know for sure what actual
hardware it is.
>Bela<
- Next message: Eric Wood: "Need Openserver 5.0.5 Media Kit"
- Previous message: Bela Lubkin: "Re: BTLD Floppy disk for Cristie CD1600"
- In reply to: Joe Chasan: "Dell PowerEdge 1600sc NIC"
- Next in thread: Nachman Yaakov Ziskind: "Re: Dell PowerEdge 1600sc NIC"
- Reply: Nachman Yaakov Ziskind: "Re: Dell PowerEdge 1600sc NIC"
- Reply: Joe Chasan: "Re: Dell PowerEdge 1600sc NIC"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|