open : I/O Error - MC_MOVE_MEDIUM failed with ADIC changer
From: philby (pmibus_at_lyq.org.au)
Date: 01/27/05
- Previous message: Rob: "Problems with SCO 5.0.6 and Informix 7.12 (long)"
- Next in thread: philby: "Re: open : I/O Error - MC_MOVE_MEDIUM failed with ADIC changer"
- Reply: philby: "Re: open : I/O Error - MC_MOVE_MEDIUM failed with ADIC changer"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Thu, 27 Jan 2005 14:35:22 GMT
I am trying to get an ADIC changer with Sony DAT drive working on Unixware
7.1 via an Adaptec aha-2940uw. The system finds the changer and drive OK
and identifies them correctly, but when I run asetup for ArcservIT, and sell
it to take controll of the devices I get "open : I/O error" twice. When I
run mccntl -i the changer initialises OK, then I can put a tape in the drive
with mccntl -l 1, and it all shows OK with mccntl -s, but I can't eject the
tape with either mccntl -e 1 or mccntl -E. It returns the error
"MC_MOVE_MEDIUM failed". Seems to me I'm so close to getting this
working...... Is this likely to be a hardware problem with the changer?
Interupt problem with the scsi card? Any ideas?
Philby
- Previous message: Rob: "Problems with SCO 5.0.6 and Informix 7.12 (long)"
- Next in thread: philby: "Re: open : I/O Error - MC_MOVE_MEDIUM failed with ADIC changer"
- Reply: philby: "Re: open : I/O Error - MC_MOVE_MEDIUM failed with ADIC changer"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
