changed cd drive to dvd-multdrive - cd doesn't work anymore
From: peri g (briard_at_kos.net)
Date: 02/19/05
- Next message: Harold Stevens: "Re: Is this board alive?"
- Previous message: Wilf5i0t: "Re: Is this board alive?"
- Next in thread: peri g: "Re: changed cd drive to dvd-multdrive - cd doesn't work anymore"
- Reply: peri g: "Re: changed cd drive to dvd-multdrive - cd doesn't work anymore"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sat, 19 Feb 2005 14:11:27 -0500
I am needing some help. I can not get
the new Dvd-multi drive to read or mount a
regular CD .
I have probably missed some configuration step.
I took out the cd drive and installed a
Panasonic Multidrive
It is recognized in the computers BIOS, and
hwconfig -h shows the same as it was before:
cd-rom type=IDE ctlr=sec cfg=mst dvr=Srom->wd
I then loaded the wdsupp for Sco 5.0.6
I then deleted the cdrom from Microlite Edge 2.1
and used Autodect to find the new Dvd. It worked
and I was able to perform a test backup.
However, I am unable to read a regular CD on
the Multidrive. I was able to read a CD before.
I also cannot mount a CD using
# mount /dev/cd0 /mnt
I get an error which suggests I have missed some
configuration:
NOTICE: Srom: Not ready reading SCSI CD-ROM 0
dev 47/0 (ha=1 bus=0 id=0 lun=0) block=488774
mount: cannot stat '/dev/cd0': No such device or address (error 6)
What steps do I need to take to fix this ?
Peri Geen
-
- Next message: Harold Stevens: "Re: Is this board alive?"
- Previous message: Wilf5i0t: "Re: Is this board alive?"
- Next in thread: peri g: "Re: changed cd drive to dvd-multdrive - cd doesn't work anymore"
- Reply: peri g: "Re: changed cd drive to dvd-multdrive - cd doesn't work anymore"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|