Re: SCO 5.0.5 dd / clone

Hi Bela,

Thanks for the reply. Indeed I tried it with both the old wd driver (as
originally delivered in 5.0.5) as well as the newer wd driver as found
in 5.0.7. The timing is DRASTICALLY diff (the old wd driver took almost
4 hrs to complete, the new wd driver finished in under 25 minutes for a
20Gb clone!!). However, the result seems to be the same - the new
clone is badly corrupted. As I mentioned previously this only happens
on a "live" running booted system. If I boot from say a CD and clone
drive 1 to drive 2 it works just fine. Again, any help or ideas to try
would be much appreciated. Rgds. Otto.

.

Relevant Pages

  • Re: SCO 5.0.5 dd / clone
    ... Indeed I tried it with both the old wd driver (as ... same - the new clone is badly corrupted. ... >> have implemented a dd cloning of the master hard disk to a backup disk. ...
    (comp.unix.sco.misc)
  • Re: SCO 5.0.5 dd / clone
    ... Indeed I tried it with both the old wd driver (as ... If I boot from say a CD and clone ... >> have implemented a dd cloning of the master hard disk to a backup disk. ...
    (comp.unix.sco.misc)
  • Re: Ultra5 to Blade100 cloning
    ... >The clone boots and appears to be an intact copy, ... whatever graphics card you are using, ... There are a group of 4-5 packages for this ... (Device Driver, DDX module, config program, manpage ...) ...
    (comp.unix.solaris)
  • Re: Ultra5 to Blade100 cloning
    ... >The clone boots and appears to be an intact copy, ... whatever graphics card you are using, ... There are a group of 4-5 packages for this ... (Device Driver, DDX module, config program, manpage ...) ...
    (comp.sys.sun.hardware)
  • Re: xp not recognizing DVI monitor
    ... Yes, via the Matrox G550 board that I have on another system, the driver provides for the option to set up a clone. ... the XFX drivers on the XP system that I am now setting up do not seem to provide such a capability; neither does the the Dell display driver. ... GF6600 DDR PCI-E board hooked to a Dell 2005FPW LCD monitor using a standard VGA cable. ... cabling issue but then the boot screen and initial load screens are ...
    (alt.comp.hardware.pc-homebuilt)