UFS Logging Error

From: Eric Enright (eric.enright_at_gmail.commmm)
Date: 03/23/05 

Date: Tue, 22 Mar 2005 18:50:18 -0600

Hi,

Immediately after burning a CD I've got /home filesystem problems.
The /home disk is on the same IDE controller as the CDR, and I'm
running Solaris 10 FCS x86.

Mar 22 19:09:59 yamano scsi: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1 (ata1):
Mar 22 19:09:59 yamano timeout: early timeout, target=0 lun=0
Mar 22 19:09:59 yamano scsi: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1 (ata1):
Mar 22 19:09:59 yamano timeout: early timeout, target=0 lun=0
Mar 22 19:09:59 yamano gda: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1/cmdk@0,0 (Disk0):
Mar 22 19:09:59 yamano Error for command 'write sector' Error Level: Informational
Mar 22 19:09:59 yamano gda: [ID 107833 kern.notice] Sense Key: aborted command
Mar 22 19:09:59 yamano gda: [ID 107833 kern.notice] Vendor 'Gen-ATA ' error code: 0x3
Mar 22 19:09:59 yamano gda: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1/cmdk@0,0 (Disk0):
Mar 22 19:09:59 yamano Error for command 'write sector' Error Level: Informational
Mar 22 19:09:59 yamano gda: [ID 107833 kern.notice] Sense Key: aborted command
Mar 22 19:09:59 yamano gda: [ID 107833 kern.notice] Vendor 'Gen-ATA ' error code: 0x3
Mar 22 19:10:34 yamano scsi: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1 (ata1):
Mar 22 19:10:34 yamano timeout: early timeout, target=0 lun=0
Mar 22 19:10:34 yamano scsi: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1 (ata1):
Mar 22 19:10:34 yamano timeout: early timeout, target=0 lun=0
Mar 22 19:10:34 yamano gda: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1/cmdk@0,0 (Disk0):
Mar 22 19:10:34 yamano Error for command 'write sector' Error Level: Informational
Mar 22 19:10:34 yamano gda: [ID 107833 kern.notice] Sense Key: aborted command
Mar 22 19:10:34 yamano gda: [ID 107833 kern.notice] Vendor 'Gen-ATA ' error code: 0x3
Mar 22 19:10:34 yamano gda: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1/cmdk@0,0 (Disk0):
Mar 22 19:10:34 yamano Error for command 'write sector' Error Level: Informational
Mar 22 19:10:34 yamano gda: [ID 107833 kern.notice] Sense Key: aborted command
Mar 22 19:10:34 yamano gda: [ID 107833 kern.notice] Vendor 'Gen-ATA ' error code: 0x3
Mar 22 19:11:09 yamano scsi: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1 (ata1):
Mar 22 19:11:09 yamano timeout: early timeout, target=0 lun=0
Mar 22 19:11:09 yamano gda: [ID 107833 kern.warning] WARNING: /pci@0,0/pci-ide@11,1/ide@1/cmdk@0,0 (Disk0):
Mar 22 19:11:09 yamano Error for command 'write sector' Error Level: Informational
Mar 22 19:11:09 yamano gda: [ID 107833 kern.notice] Sense Key: aborted command
Mar 22 19:11:09 yamano gda: [ID 107833 kern.notice] Vendor 'Gen-ATA ' error code: 0x3
Mar 22 19:11:09 yamano ufs: [ID 702911 kern.warning] WARNING: Error writing master during ufs log roll
Mar 22 19:11:09 yamano ufs: [ID 127457 kern.warning] WARNING: ufs log for /home changed state to Error
Mar 22 19:11:09 yamano ufs: [ID 616219 kern.warning] WARNING: Please umount(1M) /home and run fsck(1M)

Apologies for the long lines.

# iostat -En
c1t1d0 Soft Errors: 6939 Hard Errors: 13 Transport Errors: 0
Vendor: MITSUMI Product: CR-487ETE Revision: 001J Serial No:
Size: 0.00GB <0 bytes>
Media Error: 0 Device Not Ready: 9 No Device: 4 Recoverable: 0
Illegal Request: 6939 Predictive Failure Analysis: 0

I umounted and fscked the filesystem which came up clean, and haven't
had any problems after mounting it again. I suspect that the burning
process disrupted the log write long enough to throw an error, might
that simply be the case? Should I be concerned about this?

Thanks,
Eric

Relevant Pages

  • RE: "0 kb available" on brand-new CDR, CD Writing Wizard
    ... > problem burning to a brand-new CDR on his Windows XP machine using the ... I've asked him to go buy yet another blank CDR elsewhere, ...
    (microsoft.public.windowsxp.general)
  • Re: In the car, CD-RW works. CD-R doesnt
    ... Track at once burning can introduce click noises ... Stores that sell CDR can certainly get CDRWs as well. ... If I burn an audio CD on CD-RW it plays fine in my 2005 Altima. ... I've tried finalizing and not finalizing. ...
    (microsoft.public.windowsxp.general)
  • Re: Have to burn Bin/Cue files?
    ... >> the resulting video to my computer, instead of burning a CDR? ... then copy the video file to my computer. ... >>> replacing one that had rotted, ...
    (alt.video.dvd)
  • Re: Have to burn Bin/Cue files?
    ... I already have the .cue file. ... the resulting video to my computer, instead of burning a CDR? ...
    (alt.video.dvd)