Re: NIC configuration

Hey srob

Try telnet ip or machinename
Try this link http://acs.ucsd.edu/info/rcp.php

Joe

srobs51095@xxxxxxxxx wrote:
Please help.

I have my Sunfire V490, V480, and V440 nic's connected through a
gigabit switch configured on secondary interface ce1, ifconfig -a shows
it is up. Ping between all boxes shows alive.

I am trying to rcp files and get connection refused.

I have /.rhosts. /etc/hosts, /etc/netmasks, and file permissions
correct

Anyone have any ideas?

.

Relevant Pages

  • Re: OT: Networking advise
    ... disconnect msg, then a connected msg, @ 1.0 Gbps ... Area Connection setting after that to see if it is still 1 GB ... Are your network interfaces ... cables plus gigabit switch works, ...
    (rec.crafts.metalworking)
  • probably an easy routing question, so please help
    ... plugged into the same gigabit switch as Server B in Block 2 and they ... the other's gigabit ethernet port on the switch? ... connection between the subnets optimal? ... I'm quite sure that I'm missing some key concepts here, ...
    (comp.dcom.sys.cisco)
  • Re: Help: tip hardwire problem between SunFire 6800 and SunBlade100
    ... If there have been no physical changes then there was a software ... I recall getting this problem when modem control was turned ... You have an 8-pin connection, ... The Sunfire 6800 switched to using modem control on its ...
    (comp.unix.admin)
  • SunRay Slow screen
    ... We have a Sunfire V120 Server with 10 SunRays connected to it. ... which will start a Citrix Connection to a MetaFrame Server. ... that the SunRay screen builds up very slowly at certain times. ...
    (SunManagers)
  • Internet not working with gigabit switch
    ... I have a Soundstream 5100 DSL modem connected to the WAN port on my Hawking ... connected to port 1 on my wireless router, ... computer is connected to port 2 on my gigabit switch. ... My eventual goal is to share an internet connection with the ps2 and two ...
    (comp.dcom.lans.ethernet)