Re: Solaris 10 on Ultra 5: No disks found.
- From: "Mahy" <jkotuc@xxxxxxxxx>
- Date: 15 Dec 2006 15:14:43 -0800
On 2006-12-15, Mahy <jkotuc@xxxxxxxxx> wrote:
i bought an old but unused Ultrasparc 5 recently. First i installed
Debian on it, but i also wanted to try out Solaris. So i burned the DVD
and put it in. After a very long while, the installer showed up. I set
up me networking info and then it came: "No disks found!" I tried to
run format, but it's giving me segfault every time. Also tried it in
single-user mode, same results. The hard drive is Seagate Barracuda 20
GB, plain IDE. Thanks for any suggestions.
What is shown by »probe-ide« at the ok prompt?
Andreas.
This is it:
Device 0 (Primary Master)
ATA Mode: ST320011A
Device 1 (Primary Slave)
Not Present
Device 2 (Secondary Master)
Removable ATAPI Model: ASUS DRW-1608P2S
Device 3 (Secondary Slave)
Not Present
I think it's fairly self-explanatory and it corresponds with the actual
hardware configuration. I dunno how this is gonna help, though.
.
- Follow-Ups:
- Re: Solaris 10 on Ultra 5: No disks found.
- From: Ian Collins
- Re: Solaris 10 on Ultra 5: No disks found.
- References:
- Solaris 10 on Ultra 5: No disks found.
- From: Mahy
- Re: Solaris 10 on Ultra 5: No disks found.
- From: Andreas F. Borchert
- Solaris 10 on Ultra 5: No disks found.
- Prev by Date: mnt point vslinks
- Next by Date: Re: Solaris 10 on Ultra 5: No disks found.
- Previous by thread: Re: Solaris 10 on Ultra 5: No disks found.
- Next by thread: Re: Solaris 10 on Ultra 5: No disks found.
- Index(es):
Relevant Pages
|
|
