rsync 2.5.6 configure error

From: Dale Renton (dale_renton_at_hotmail.com)
Date: 05/20/03

  • Next message: carloseuv: "Setup Unix tru64" 
    Date: Tue, 20 May 2003 10:09:43 -0300

    I'm trying to get rsync 2.5.6 working with Tru64 5.1A.

    I downloaded the source file. When I run configure I'm getting the
    following error in a loop :

    ./config.status[478]: /tmp/cs413248-13307/subs.frag: file already exists

    Here are lines 468 to 500 from the config.status file :

      # Split the substitutions into bite-sized pieces for seds with
      # small command number limits, like on Digital OSF/1 and HP-UX.
      ac_max_sed_lines=48
      ac_sed_frag=1 # Number of current file.
      ac_beg=1 # First line for current file.
      ac_end=$ac_max_sed_lines # Line after last line for current file.
      ac_more_lines=:
      ac_sed_cmds=
      while $ac_more_lines; do
        if test $ac_beg -gt 1; then
    line 478 >>> sed "1,${ac_beg}d; ${ac_end}q" $tmp/subs.sed
    >$tmp/subs.frag
        else
          sed "${ac_end}q" $tmp/subs.sed >$tmp/subs.frag
        fi
        if test ! -s $tmp/subs.frag; then
          ac_more_lines=false
        else
          # The purpose of the label and of the branching condition is to
          # speed up the sed processing (if there are no `@' at all, there
          # is no need to browse any of the substitutions).
          # These are the two extra sed commands mentioned above.
          (echo ':t
      /@[a-zA-Z_][a-zA-Z_0-9]*@/!b' && cat $tmp/subs.frag)
    >$tmp/subs-$ac_sed_frag.sed
          if test -z "$ac_sed_cmds"; then
       ac_sed_cmds="sed -f $tmp/subs-$ac_sed_frag.sed"
          else
       ac_sed_cmds="$ac_sed_cmds | sed -f $tmp/subs-$ac_sed_frag.sed"
          fi
          ac_sed_frag=`expr $ac_sed_frag + 1`
          ac_beg=$ac_end
          ac_end=`expr $ac_end + $ac_max_sed_lines`
        fi
      done

    What can be done to correct this?

    Thanks,
    Dale

  • Next message: carloseuv: "Setup Unix tru64"
    • Quantcast